KNX2GO

KNX2GO is the mobile tool for commissioning and diagnosing KNX systems – directly from your smartphone, without a laptop at the distribution board.

Connect to the KNXnet/IP interface and get started:

• Commissioning – assign physical addresses: via serial number, programming button, or FDSK scan (KNX Secure); overwrite or reset to factory settings.

• Label printing – print address labels directly on-site (NIIMBOT D110).

• PA test – check if an address is responding, including device information.

• Device identification – switch or blink the Prog LED.

• Line scan – automatically scan a line for devices.

• Topology – couplers and hop paths clearly displayed as a diagram.

• Monitor – group and bus monitor: read telegrams, read and write values.

ETS Sync Bridge: retrieve the project plan (group addresses + devices) from the ETS6 extension "KNX Go" to your mobile phone via QR code. Verified addresses are automatically fed back into the open ETS project – including the commissioning report.

For electrical professionals and KNX integrators. The connection and bridge operate on the local network; optional remote access via the EisBär portal. Available in 6 languages ​​(DE/EN/FR/IT/ES/FI).