GeoFaker - Fake GPS Location

GeoFaker is an app that fakes your Android device's current location (mock location), placing it anywhere you like.

Tap the map to drop pins, and it emulates moving along the route connecting them at a speed you specify. It's a tool for reproducing, right at your desk, the situations you'd otherwise have to walk around outside to test when checking or debugging location-aware apps.

■ Who it's for
・Those developing location-aware apps who want to check behavior while on the move
・Those who want to test map, navigation, or check-in apps by reproducing being in a specific place
・Those who want to repeat verification runs along the same route at the same speed every time
・Those who want to finish location testing indoors, without carrying a device around

■ Key Features

【Dropping Pins on the Map】
Add a pin at the center of the screen, remove them one at a time from the end, or clear them all at once. Pins can be dragged to reposition, are connected by lines to form a route, and numbered markers show their order. You can place up to 20 pins.

【Location Emulation】
Reproduces continuous movement along the route connecting your pins at the speed you specify. A foreground service handles the location updates, so emulation keeps running while you use other apps and while the screen is off. With only one pin, the location stays fixed at that point instead of moving.

【Movement Modes】
Choose from four ways to run the route.
・Loop: returns to the start after reaching the end and repeats the same route
・Reversal: turns around at the end and travels back the way it came
・Cycle: moves to the start point after reaching the end
・Terminate: stops once it reaches the end

【Speed Setting】
Specify the travel speed as a number. You can switch the unit between km/h and mph in Settings.

【Saving and Loading Emulation Settings】
Save your pin list, speed, and movement mode under a title, and recall it whenever you need it. Register the test routes you use often and you can reproduce the same conditions with a single tap next time. You can save up to 50 settings.

【Info Panel】
Always shows the emulation status and the coordinates at the center of the map. Expand it to also see the emulated coordinates, speed, and movement mode at a glance.

■ Before You Use
・To use this app, you must enable Android's "Developer options" and select GeoFaker under "Select mock location app." If it isn't set, the app will guide you to the settings screen.
・A foreground service runs during location emulation, so notification permission is required.
・Some apps detect mock locations and may restrict their use.
・This app is intended for development and testing purposes. Please avoid any use that violates the terms of service of other services.

Just drop pins on the map and reproduce exactly the movement you want. Give GeoFaker a try.