Pool Light Control

Control LED Swimming pool lights through the WiFi function of the mobile device, it makes the LED pool light control intelligent and humanized.

Supports Android system 4.0 or above
Language: English, Chinese
Free, safe, no Plug-in

There are two kinds of control ways for this APP: single-point mode and routing mode.

Single point mode：
1：Enter "Join Routing" interface.
2：Click the single point mode button → Tips: Please connect the hotspot starting with Pool_light→ TO SET
3：In Settings -> Wireless LAN -> find hotspot signal link for Pool_light_XXXXXXX
(initial password 123456789)
4：Back to the Scene interface
5：Select the online device, click to create a scene, and then click "Control" to enter the control interface.

Routing mode:
1.Open the software, enter the "Add to Route" interface, click on the routing mode, the "Add to Route" interface pops up, enter the account and password of the local router;
2.Send the router information to the connected control box, the control box will automatically connect to the router after the transmission is successful;
3.When the control box is successfully connected to the router, you will see 3 green lights flashing on the lamp (when the lamp is connected normally)
4.Follow the above steps to connect the controller to be controlled to the router
5.If the control box is successfully connected to the router, the control box will become the client state, and all the Pool_light_xxxxxxxx signals sent by it will disappear;
6.If you find the WiFi signal of Pool_light_xxxxxxxx in the LAN list of your phone, it means that the device has been restored to the factory state, and you need to add it to the router again router again
7. There are two types of Router mode offline operation instructions. One is to select an online device on the "Online Devices" interface on the APP, and then click the offline device in the upper left corner; the other is to hold down the R and S+ keys on the control box at the same time, and then wait for the red light flashing three times, exit routing mode.
※Note: After the device is powered off and re-powered, it will connect to the router connected before the power off. Connection success and failure phenomena are the same as described above.