Wifi Rig CTRL

Two ways to connect: Via Raspberry Pi (Hamlib/FastAPI): CAT control for a wide range of radios, plus receive audio, CW, FT8 and APRS Direct CI-V connection: join the same Wi-Fi network as an IC-705 or IC-9700 for basic operation without a Raspberry Pi ■ Key Features Real-time display of receive frequency, mode and signal strength (S-meter) Change frequency, mode, transmit power, squelch and filter width Receive audio played through the speaker, with noise reduction PTT on/off and microphone audio transmission Wi-Fi PTT (PTT control from an external device such as an M5Atom) CW decoding of up to 5 stations at once, and CW transmission with presets and adjustable WPM BLE CW keyer support (connect a DualKey-BLE or RemoteKeyer-BLE over Bluetooth) FT8/FT4 decoding and transmission APRS beacon transmission using the phone’s GPS Multiple profiles for switching between connection targets API key authentication and remote access over WireGuard VPN ■ Requirements (Important) This app does not work on its own. You need one of the following, owned by you: A Raspberry Pi Zero 2W that is already set up (connected to your radio, with Hamlib/FastAPI installed), or An IC-705 or IC-9700 (for a direct CI-V connection) Connect either one to the same Wi-Fi network as your iPhone. Setup instructions and firmware for the Raspberry Pi are available on GitHub: https://github.com/ji1ore/M5CoreHamCAT ■ Intended Users This app is for licensed amateur radio operators who have a compatible radio setup. *This app contains no ads and no usage tracking. All data it collects is used only on your device and is never sent to an external server.