Snap-on EEDM604F

• Color VA Type LCD Display: 50,000 count with 51 segment bar graph

• Triple Display: Activated with REC, REL, PEAK-H buttons

• REC (Record Mode): Store minimum, maximum and average readings over a measurement period

• RANGE: Manual range option for each function

• PEAK-H: Peak hold button engages .25 millisecond rapid signal capture function to catch glitches

• COMP (Compare): Activates the compare function to compare your reading against a known standard

• REL% (Relative Percent Mode): Factor out lead resistance for improved low ohm measurements or compare readings to a known standard—can also be used for differential measurements

• EDIT: Use in conjunction with the COMP and arrow buttons to set the standard value for comparing readings

• Gray button: Use to select gray functions noted on meter

• HOLD: Lock the reading on the display for hard to read locations for future reference

• Ohms, Conductance, Continuity: Toggle between measuring resistance, conductance and continuity buzzer

• ACmV/DCmV(AC or DC millivolts): Measure up to 500 AC or DC millivolts

• ADP (Adaptor Mode): Direct readout on the LCD when using optional accessories

• DCV (DC Volts): Measure up to 1,000 V

• ACV/Hz (AC Volts and Frequency): Measure up to 1,000 V AC—push the grey button to view frequency, duty, and mS pulse width of the signal

• Diode Test: Test for good, open, or shorted diodes in circuits

• CAP (Capacitance): Measure the capacitance of condensers and capacitors

• Hz (Frequency): Measure the frequency, duty and pulse width of sensors and signals—also used to measure temperature (gray button)

• AC/DC Current Functions (Amps): Measure the parasitic draw from the battery with ignition off

• External Testing of Internal Fuses: Determine the status of the internal fuses before you open the battery/fuse compartment

• Protective boot and built-in tilt stand

• Technical Support 888-382-6522