Nyas - STM32 Programming Suite

Nyas turns an Android phone or tablet into an STM32 programmer. Connect an ST-Link probe over USB OTG and flash, read, verify or erase firmware on a target board without a laptop. Flash multiple boards hands-free using Batch mode.

The app has no file size restrictions, collects no data, and shows no ads.

Write .bin and .hex firmware to STM32 targets over SWD. Read flash back from the device, verify a binary against it, or erase the chip. Detect the target automatically and report chip ID, flash size, SRAM size, ST-Link hardware version and expected chip series. Edit option bytes, including watchdog selection, nRST_STOP, nRST_STDBY, user data bytes, flash write protection and read protection level 1.

CONNECTION CONTROL

SWD clock selectable across twelve steps from 5 kHz to 4 MHz. Connection modes: normal, connect under reset, and hot plug. Optional manual start address and flash size override.

LOGGING

Every operation is logged with millisecond timestamps. View the log as a flat event stream or grouped per command with elapsed time for each step. Filter by command, app, error or warning, search the buffer, and share a session.

HARDWARE

Works with ST-Link V2, V2-1 and V3 probes. Requires a device with USB OTG support running Android 8.0 or later, plus a USB OTG adapter or cable.

PRIVACY

Nyas has no internet permission and requests no runtime permissions. USB access is granted by the system per device when you connect the probe. Nothing is collected, transmitted or stored off the device.

OPEN SOURCE

Built on stlink (BSD 3-Clause) and libusb 1.0.29 (LGPL 2.1). Full licence texts and source links are in the app under About.

TRADEMARKS

STM32 and ST-LINK are trademarks or registered trademarks of STMicroelectronics. Nyas is an independent tool and is not affiliated with or endorsed by STMicroelectronics.