Sheep Counter

For the flight planner (NON-manual flight):
1. Turn on drone and controller, and open the app on the phone.
2. Plug controller into phone over USB.
3. Wait for a popup asking for which app to handle the USB device. Choose sheep counter.
4. After a short few seconds, it should show connected. If it doesn't work, this is usually because DJI Go is installed and set to be the default when you plug in the drone controller. Steps for clearing that are device specific.
5. Select "Flight Planner" at the top. It will ask to clear the drone's SD card. Once that's done you can tap on the map to create an area.
6. Click "Create flight plan" at the bottom, and you should see a grid pattern appear on screen.
7. Press "Start Flight" and the drone should take off and fly the route. Afterwards there is a "stitch photos" button on the main screen or it will allow you to do it immediately.

For manual flight:
1. Do steps 1-4 from the previous list.
2. Press the big button that animates in once the drone is connected.
3. Fly normally and it will give you a video feed with boxes that the model detects.

Designed for Phantom 4.