Calculation of the wire mesh

About Calculation of the wire mesh

Often when working with wire mesh you need to know its mass, length and the number of bars, so for simplicity and convenience, this mesh calculator was created so that you could answer these questions any time.

How it works:
1. Fill in all the fields (diameter of the long and cross bars, the length and width of the mesh, and the bar spacing)
2. Press the "Calculate" button
As a result of the calculation, all the unknown data will appear in the table.

For reference:
- if the value for the rebars is zero (which will not allow to make a normal reinforcing mesh), the column will turn red and you will need to either change the size of the mesh or change the spacing for the corresponding wires
- according to the state standard 23279-2012 "Welded reinforcing mesh for concrete constructions and products", the mesh width must be 650mm to 3800mm and its length must be greater than 850mm.