MyAlarm iFob Control

About MyAlarm iFob Control

NOTE:
This app requires a compatible security system and an interactive MyAlarm service plan to function.
Contact your MyAlarm Registered Installer to discuss plans and options before purchasing the app.


DESCRIPTION:
The MyAlarm iFob Control app provides real time control and feedback of compatible, IP enabled alarm systems.
Reporting of alarm events via Push notification and email is also available if required.

Users can arm and disarm areas, control outputs and doors, view system troubles and alarm system history as required.
All events performed via the app are recorded in the system history log.
App users are required to use their normal alarm PIN when using the app allowing the alarm system to restrict the user to only functions, areas and doors they have access to. Multiple sites are supported allowing easy interface to your home, office and holiday house etc if required.

Once on a MyAlarm service plan the system owner can create an account on the www.myalarm.com.au web site, where they can assign access for up to 10 iFob users for each alarm system. Various app functions can be restricted by the system owner if required giving them total control.
If you are in doubt how to set these options contact your MyAlarm registered installer for assistance.


COMPATIBILITY:
The iFob app is currently only compatible with the panels listed below.
Most older version panels can be upgraded to meet the firmware requirements by your alarm installer.
If you do not have one of the systems listed then do not download the app.

PANELS:
* Bosch - Solution 144 Alarm Panel (via firmware upgrade to Solution 6000 v2.23 and higher)
* Bosch - Solution 6000 Alarm Panel (v2.23 and higher)
* Digiflex - Vision-X Alarm Panel (v2.23 and higher)

IP CONNECTIVITY OPTIONS:
* CM751 Ethernet module (v2.16)
or
* CM744 3G Radio module
or
*CP740 WiFi Enabled Graphic Keypad

REQUIREMENTS:
For the iFob Control app to function your system needs to meet the compatibility requirements listed above.
Your system needs to have been installed and configured for MyAlarm services and you will need to sign up for a MyAlarm service plan with your installer.
A MyAlarm Customer account is required to setup the iFob Control app users for your system.

Contact your MyAlarm installer for more information regarding your alarm system configuration and MyAlarm service plan options.